Cornice Repair & Replacement Contractors In New York

The cornice is the part of the building nobody looks at — until it leaks, sags or drops something. It is also a working water detail: the projecting crown at the top of the facade exists to throw rain clear of the wall, and when its seams open or its metal rusts through, every storm starts a facade problem at the top floor. We repair and replace cornices across New York by their material — pressed sheet metal, wood, masonry and cast stone — repairing sound fabric, and replacing failed sections from templates taken off the surviving original, so the profile your building was built with is the profile it keeps. Brownstones, rowhouses and older small buildings are our ground. Every cornice is assessed in person first. Request a free estimate using the form on this page.

Request An Estimate

Tell us a little about your project, and our team will review your requirements and get in touch to schedule a free estimate.
Worker on a scaffold repairing an ornate decorative cornice along the roofline of a brick building in New York

About Our Cornice Repair & Replacement Services

A cornice scope starts with a material question, because each material fails its own way and is fixed its own way. Galvanised sheet metal — the classic New York pressed-metal cornice, soldered and painted — rusts at its seams, drip edges and laps wherever the paint film lapses, and rust-through there is a section problem, not a paint problem. Wood cornices rot at joints and end grain, under sound-looking paint. Masonry and cast stone cornices crack at joints and units as water enters and freezes, and cast iron — rarer, heavier — corrodes at its fixings until sections shift. GFRC and fibreglass replication enters only where a landmark profile must be reproduced and the original cannot honestly be reinstated. Name the material correctly and most of the repair method names itself.

The work follows. Sound metal is cut back to bright material, patched or re-formed, its seams re-sealed and the whole repainted; rotted wood is cut out and scarfed or replaced in kind; masonry is repointed or rebuilt unit by unit. Replacement is reserved for what is gone — and where a section is replaced, its profile is templated from the surviving original beside it, so the crown reads as one cornice, not a patch. Two neighbours meet at the cornice and are scoped with it: the parapet wall rising behind the roofline and the roof edge — the flashing at those junctions is part of this work — while the facade below, which inherits every cornice failure as a stain or a spall, is programmed on our facade repair and restoration page.

What Is Cornice Repair & Replacement?

Strip the ornament away and a cornice is a gutter’s opposite: a shaped projection whose whole job is to catch the wall’s top edge and throw the water running down the facade clear of the face below. The drip at its outer edge is the working detail — water leaves the building there, in free fall, instead of crawling back along the underside into the wall. Some metal cornices carry an internal gutter as well, which makes their seams doubly important. The decoration is real too — the cornice is the building’s signature at the skyline, the profile neighbours read it by — but it earns its keep as plumbing first. That is why cornice failure is never only a cornice problem. An open seam wets the top of the wall on every storm; the top floor’s ceiling stains are the cornice confessing indoors; brackets and anchors corrode in the wet until the line sags; and loose material at height becomes a risk to the pavement below. Repair restores the decoration, certainly — but the scope that matters restores the water detail: projection, drip, seams and flashing, working as one.

Types Of Services We Offer

Cornice Repair & Replacement Programmes

The projecting crown read by its material and repaired as one scope — seams, flashing, fixings and profile — for brownstones, rowhouses and older small buildings.

Sheet Metal Cornice Repair

The classic pressed-metal cornice: rust cut back to bright material, failed sections patched or re-formed, seams re-sealed and the whole repainted as a system.

Profile-Matched Section Replacement

Failed sections replaced from templates taken off the surviving original beside them — profile, depth and detail carried across the joint, never approximated from a catalogue.

Cornice Flashing & Roofline Junctions

Where the crown meets the parapet and the roof edge: flashing renewed as part of the cornice scope, because a sound cornice over an open junction still leaks.

Parapet Wall Repair & Coping

The neighbour above the roofline: the parapet wall and its coping — the wall extension behind the cornice — are repaired at depth on our parapet page.

Searching for Cornice Repair & Replacement Contractors Near Me?

If you are searching for cornice repair near you in New York, look up first — literally: the cornice line tells you its condition from the street, in rust streaks, open seams and a sagging profile, long before it tells you indoors. RT General Construction Inc is based in Yonkers and repairs and replaces cornices across Westchester County, the Bronx, Manhattan and Queens, on the brownstones, rowhouses and older small buildings that carry them. Access — ladders, lifts or scaffold — is planned per building and named in the scope. Every cornice is assessed in person — from the street, and up close where access allows — and the written scope separates repair from replacement section by section, so sound original fabric is never condemned for the sake of a bigger job. The work sits at the top of our exterior repair and renovation service, between the parapet behind it and the facade below. Call us or send the form on this page to arrange a free estimate at your property.

Finished restored decorative cornice running along the top of a red brick building in New York

The Crown Repaired By Its Material — And Kept In Profile

Every older facade in New York wears a cornice, and almost nobody owns the craft of it — it is a passage in other firms’ brochures. Here it is a page, a scope and a discipline: the material identified before the method, sound fabric repaired rather than condemned, failed sections replaced from templates taken off the surviving original, and the flashing at the parapet and roof junctions renewed with the crown. The result reads as one cornice from the street — and stops leaking into the top floor behind it.

A Small Element With A Whole Wall Below It

The cornice throws water clear of everything beneath it. Its failure is the top of every facade problem — so it is scoped like the system part it is.

The Profile Is The Building's Signature

Replacement sections are formed from your own cornice’s surviving profile. A catalogue approximation on an ornamental crown reads as damage, not repair.

Neighbours Named, Not Absorbed

The parapet behind and the roof beside the cornice are their own scopes and their own pages. Each is named and linked — never quietly folded into this one.

Process, How we Works.

01

Rust Streaks And Rust-Through At Seams

On a metal cornice, staining below a seam is the paint film reporting rust under it; holes at seams and drip edges are the same story finished. Seams are where metal cornices live and die.

02

Open Seams, Lifted Edges And Peeling Paint

The finish failing exactly where water moves: joints working open, edges lifting, paint letting go over damp substrate. Each open seam is a funnel into the top of the wall.

03

A Sagging Or Uneven Cornice Line

The profile no longer runs true because its brackets and anchors have corroded in the wet behind it. Sagging is a structural sentence about fixings you cannot see — read it as one.

04

Stains On The Top-Floor Ceiling Or Wall

Water appearing at the highest ceiling in the building is the cornice confessing indoors: its seams or flashing have opened, and every storm is entering at the crown.

Benefits Of Hiring Us In New York

A cornice is judged from the street and from the top floor — by its line, and by the stains it never causes. Here is what a material-led scope gets you.

Material Identified Before Method

Metal, wood, masonry and cast stone each get their own repair logic, because the wrong method on the wrong material is how cornices get repaired twice.

Profile Kept, Not Approximated

Replacement sections are templated from the surviving original beside them, so the crown reads as one continuous profile — the building keeps the face it was built with.

The Junction Sealed With The Crown

Flashing where the cornice meets the parapet and the roof edge is part of this scope, because a sound cornice over an open junction still leaks.

Repair Before Replacement, Told Straight

Sound substrate under a failed finish is a repair, and that is the scope you get. Replacement is argued section by section, from evidence, never by default.

Proven Quality, Best Results

Built on Trust, Proven By Testimonials

98% Clients Are Positive Reviews 1 2

Google
SYED ALI profile picture
SYED ALI
Google star 1Google star 2Google star 3Google star 4Google star 5Trustindex verifies that the original source of the review is Google.
Very honest and reliable company. Work was neat, would recommend them.
Google
Fixmy Car profile picture
Fixmy Car
Google star 1Google star 2Google star 3Google star 4Google star 5Trustindex verifies that the original source of the review is Google.
They installed new concrete steps and renovated my patio. Durable work and professional contractor
Google
linda cindy profile picture
linda cindy
Google star 1Google star 2Google star 3Google star 4Google star 5Trustindex verifies that the original source of the review is Google.
Very professional flooring. Demo and install done in 48 hrs
Google
Ahsan Iqbal profile picture
Ahsan Iqbal
Google star 1Google star 2Google star 3Google star 4Google star 5Trustindex verifies that the original source of the review is Google.
They renovated my kitchen and painted my house. Work was clean and quality was very good. Highly recommend.

Clear Answers to Your Construction Questions

Cost turns on the cornice’s material, the extent of the rust, rot or joint failure the assessment finds, the complexity of the profile — a plain galvanised crown and a deep ornamental one are different work — the access the building needs, and any landmark requirements the property carries. Repair and replacement price very differently, and most cornices need some of each, section by section. We assess in person and price the written scope by section, so the figure rests on your cornice’s actual condition.

Repair where the substrate is sound: open seams re-sealed, failed paint stripped and renewed, localised rust cut back to bright metal, joints repointed, rotted wood ends scarfed out. Replacement where the material itself has gone: rust-through across a section, rot through a member’s depth, sections displaced or missing, profile lost. The honest answer is usually a map, not a verdict — some sections repaired, some replaced — and the assessment draws that map before any price is attached to it.

Four families cover most of New York’s stock. Pressed galvanised sheet metal — the classic city cornice — fails at seams and laps and is repaired by cutting back, patching or re-forming sections and re-sealing. Wood rots at joints and end grain and is cut out and scarfed or replaced in kind. Masonry and cast stone crack at joints and are repointed or rebuilt unit by unit. Cast iron corrodes at its fixings and is heavy, specialist work. Each material’s failure looks different and is fixed differently — which is why the material is identified before any method is proposed.

It can be, and plainly: loose or displaced cornice material at height is a falling hazard over the pavement below, and it should be treated as a prompt item rather than a cosmetic one. As general guidance, on New York City buildings taller than six stories cornices are also appurtenances examined under the facade inspection programme — conditions there are reported by the owner’s QEWI, and repairs from such a report run under our Local Law 11 process. We repair cornices; we do not inspect or rate them.

Yes — that is the normal method, not an exception. The surviving original beside the failed section is measured and templated, and the replacement is formed or cast to that template, so profile, depth and detail carry across the joint. On landmarked buildings the same process serves the approved scope: approvals are the owner’s application, and we work to what is approved. What we will not do is substitute a catalogue profile that merely resembles yours — on an ornamental crown, resemblance reads as damage.

Proudly Serving Across New York

From interior renovations to exterior restoration, RT General Construction Inc delivers dependable construction and remodeling solutions for residential and commercial properties across New York. Our team handles everything from masonry, concrete, roofing, and exterior repairs to kitchens, bathrooms, painting, and interior improvements.

Let's Build Something Amazing Together

Tell us about your project and we will arrange an assessment, explain what the work involves and provide a written scope before anything begins. One contractor, one plan, one accountable team — that is how RT General Construction Inc runs every job, large or small.