Flooring Installation & Refinishing Contractors In New York
Request An Estimate

About Our Flooring Installation & Refinishing Services
The refinish-or-replace decision is an evidence question, and it is answered at floor level. First, the wear layer: a solid hardwood floor can only be sanded so many times before the sander reaches the tongue and the board itself is finished — a floor on its last sanding is a replacement wearing a refinishing quote. Second, the damage pattern: grey traffic wear and a dulled finish are surface facts that sanding erases, while cupping, deep gaps and black water staining at sinks and exterior doors are board facts that sanding reveals but cannot repair. Third, the water history — a floor that has been wetted and dried repeatedly can look presentable and still be done. We read all three before recommending either scope, as part of our wider interior renovation and remodeling work, and we show you what we found.
New flooring gets the same honesty from below. A floor is only as sound as what it sits on, so subfloor condition, flatness and moisture are checked and corrected inside the installation scope — never discovered halfway through a laid floor. Material choice is explained in your home’s own terms: solid versus engineered wood in rooms with steam-heat humidity swings, wide planks and the seasonal movement they honestly bring, resilient plank flooring where water and hard wear argue for it. The floor is laid for traffic and for the seasons, with its transitions into the rooms around it planned rather than improvised.
What Is Flooring Installation & Refinishing?
Refinishing is the renewal of a floor in place: the worn finish and a thin layer of wood are sanded away in stages, damage is addressed board by board where the boards allow it, stain is applied where a colour change is wanted, and a new finish system is built up on a floor that never left the house. Installation runs the journey in reverse: the old flooring is removed or properly prepared over, the subfloor is repaired and levelled, underlayment is laid, and the new material is installed with the room every floor needs to move across New York’s heating seasons.
One boundary keeps this page honest: tile in dry areas — entries, halls, living spaces — is floor work and lives here, while the waterproof tiling systems inside kitchens and baths are wet-room work and belong to those rooms’ pages, such as our bathroom renovation scope. And in an apartment, a floor is also a building question: many co-ops and condos impose sound-underlayment requirements for the sake of the unit below, which is why apartment floors are scoped with the building’s rules from the very start.
- Our Services
Types Of Services We Offer
Hardwood Floor Installation
New hardwood laid on a subfloor that has been checked, repaired and levelled first — solid and wide-plank floors installed for traffic and for the seasons.
Hardwood Floor Refinishing
Existing floors sanded back through the worn finish, repaired board by board where boards allow, stained where wanted and finished as a new surface.
Refinish-Or-Replace Assessment
The diagnosis before any quote: wear layer measured, damage pattern read, water history checked — so the recommendation follows the evidence, not the sale.
Engineered Wood & Resilient Plank Installation
Engineered boards and luxury vinyl plank installed where humidity swings or hard wear argue against solid wood — explained honestly against the alternatives.
Subfloor Repair & Leveling
The project underneath the project: bounce, slope and squeaks corrected and moisture checked, so a new floor never inherits the old one's faults.
Dry-Area Floor Tile
Tile floors for entries, halls and living spaces — set true over a prepared base. The waterproof tile systems of kitchens and baths live on those rooms' own pages.
Apartment & Co-Op Flooring
Floors inside shared buildings — sound-rated underlayment for the unit below, work windows and elevator logistics scoped with the floor from the start.
Flooring Within A Full Renovation
The floor as one stage of a whole-home programme — timed against cabinets, trim and paint, with transitions into every room planned as one story.
Searching for Flooring Contractors Near Me?
If you are searching for flooring contractors near you in New York, ask the question that predicts the result: who decides whether this floor should be refinished or replaced — and what are they selling? RT General Construction Inc is based in Yonkers and installs and refinishes floors across Westchester County, the Bronx, Manhattan and Queens, as standalone projects and as the floor stage of our wider interior renovation and remodeling programme. Every floor is assessed in person — wear layer, board damage, water history, subfloor — and the written scope states the diagnosis alongside the price, including the cases where the honest answer is the smaller job. Apartment floors carry their building’s underlayment, work-hour and approval requirements inside the scope from the start, a side covered at building depth on our apartment and condo remodeling page. Call us or send the form on this page to arrange a free estimate at your property.

- Why Choose Us
The Right Call On The Floor You Have
- Wear Layer Tells The Truth
- Damage Read Board By Board
- Subfloor Never Assumed Sound
- Floors Sequenced With The Rooms
- Apartment Rules Scoped In
- Species & Finish Explained Plainly
Refinishing Argued Both Ways
What Sanding Day Actually Looks Like
Transitions Planned Room To Room
- Our Process
Process, How we Works.
01
A Wear Layer On Its Last Sanding
Boards already sanded down close to the tongue, nail heads beginning to show at the edges: one more sanding cuts into the joint itself. This is the replacement case, however attached you are to the floor.
02
Surface Wear On Sound Boards
Grey traffic lanes, finish worn to dull wood in the doorways, light scratching that catches the light: the classic refinish case — the floor is tired, not finished.
03
Water History In The Boards
Cupping that never flattened back, black staining around sinks, radiators and exterior doors: water has changed the boards themselves, and refinishing would polish the evidence, not remove it.
04
A Subfloor That Slopes Or Gives
Bounce underfoot, squeaks, a visible fall across the room: new flooring laid over it inherits every fault. Here the real project is underneath the floor, first.
- Benefits
Benefits Of Hiring Us In New York
A floor is a diagnosis before it is a purchase. Here is what that discipline gets you.
The Honest Call, Either Way
Refinish and replace are both scopes we carry out, so the recommendation is free to follow the wear layer and the boards — not the bigger ticket.
Subfloor Treated As Part Of The Floor
Levelling, repair and moisture checks sit inside the installation scope, so the new floor’s problems are not inherited from underneath it.
Sequenced With The Renovation
Inside a wider project the floor is timed against cabinets, trim and paint, and its transitions into every adjoining room are planned as one surface story.
Apartment Rules Built In
Sound underlayment, work windows and elevator logistics for co-op and condo floors are scoped with the floor itself — not raised by the building afterwards.
- Our Projects
Proven Quality, Best Results
- Testimonials
Built on Trust, Proven By Testimonials
98% Clients Are Positive Reviews 1 2
- Our Faq
Clear Answers to Your Construction Questions
Should I Refinish Or Replace My Floors — How Can I Tell?
Read three things: the wear layer (how much wood sits above the tongue, and how many sandings the floor has already had), the damage pattern (surface wear refinishes away; cupping, deep gaps and water staining live in the boards), and the water history. Some floors pass on all three and are excellent refinish candidates; some fail one and are not. We make the call at the assessment, at floor level, and show you the evidence either way.
How Long Does Refinishing Or Installation Take — And When Can We Use The Floor?
Refinishing runs as a sequence — sanding, any board repairs, stain where wanted, then finish coats with drying time between them; installation runs removal, subfloor preparation, laying and trim-out. The honest variables are the area involved, the board repairs found, and the finish system’s curing time before furniture returns and rugs go back down — finish choice changes that wait. Your written programme states the sequence, and the walk-on and furniture-back points for your floor, before work begins.
How Much Dust And Odour Does Sanding Actually Involve?
Modern sanding equipment captures the great majority of dust at the machine, and the work rooms are sealed and protected as part of the scope — but the honest answer is that it is not zero, and fine dust can settle beyond the work room in any real house. Odour turns on finish choice: water-based finishes are markedly milder than traditional oil-based ones, and the trade-offs between them are part of the material conversation at the assessment.
What Does Flooring Installation Or Refinishing Cost In New York?
Cost turns on the area, which of the two scopes the diagnosis supports, the material chosen for a new floor, the subfloor preparation the rooms honestly need, the volume of board repairs on a refinish, stain and finish selections, and — in apartments — building requirements such as underlayment. We assess in person and price the written scope, so the figure rests on your floor’s actual condition rather than a per-foot average.
Can Floors Be Installed Or Refinished In A Co-Op Or Condo?
Generally, yes — with the building planned in. Many boards require sound-rated underlayment under new hard flooring to protect the unit below; the system side of that question is covered on our soundproofing and insulation page, and work hours, elevator bookings and the approval process are covered on our apartment and condo remodeling page. We establish your building’s exact requirements at the assessment. Treat this as guidance, not legal advice.
- Services Areas
Proudly Serving Across New York
From interior renovations to exterior restoration, RT General Construction Inc delivers dependable construction and remodeling solutions for residential and commercial properties across New York. Our team handles everything from masonry, concrete, roofing, and exterior repairs to kitchens, bathrooms, painting, and interior improvements.
- New York
- Jerome Park, NY
- Village of Pelham, NY
- Harlem, NY
- Eastchester, NY
- North Side, NY
- Yonkers, NY
- New Rochelle, NY
- Pelham Manor, NY
- Mamaroneck, NY
- Larchmont, NY
- Tuckahoe, NY
- Hastings-on-Hudson, NY
- Scarsdale, NY
- Bronxville, NY
- White Plains, NY
- Manhattan, NY
- Astoria, NY
- Long Island City, NY
- Fresh Meadows, NY
- Flushing, NY
- Bayside, NY
- Queens, NY
Let's Build Something Amazing Together
Tell us about your project and we will arrange an assessment, explain what the work involves and provide a written scope before anything begins. One contractor, one plan, one accountable team — that is how RT General Construction Inc runs every job, large or small.