Stucco Patching & Repair Contractors In New York
Request An Estimate

About Our Stucco Patching & Repair Services
The patch discipline starts with a tap. Sounded across the elevation, a stucco wall reports itself: bonded coats ring solid, while delaminated areas — coats separated from the masonry or lath beneath — answer hollow. That survey, not the visible stain or crack, sets the patch’s true boundary, because failed stucco almost always extends beyond what shows. The cut-back principle follows, and it is stated as honesty, not upsell: a patch is only as sound as its edges, so failed material comes out to where the coats are bonded and the substrate is sound — even when that makes the patch bigger than the damage you called about. A smaller patch laid over hollow edges is a repair already scheduled to fail.
Cause comes before coats. The entry point or substrate failure behind the patch — an unsealed penetration, a failed sill detail, water tracked from above — is corrected in the same scope, or the patch is cosmetic. Then the rebuild follows the wall’s own construction: scratch, brown and finish coats over masonry, or over lath where the wall is framed, each coat given its cure before the next. One boundary is named in the first conversation: this is cement stucco work. EIFS — foam, mesh and a thin synthetic finish — is a different assembly with a different repair logic, and a stucco patch method is never applied to it. The wider programme, brick alongside stucco, sits on our brick and stucco contractors page, and where a whole elevation needs restoring as one programme, that scope runs through our facade repair and restoration work.
What Is Stucco Patching & Repair?
Stucco is a layered skin, not a surface. A traditional wall is built in coats — a scratch coat keyed into masonry or lath, a brown coat that builds the plane, and a thin finish coat that carries the texture and colour — and the three work as one system that sheds most water at its face and breathes out what gets in. A patch, properly understood, is a small rebuild of that system: not filler in a hole, but the failed coats removed and the same layers reconstructed in the same order, bonded at sound edges, so the repaired area sheds, moves and weathers with the wall around it.
That is why patch quality is invisible in the wrong way twice over. A surface fill looks finished on the day and fails within seasons, because none of the layers beneath it were restored. A true patch can look slightly fresher than its weathered neighbours at first — new finish against aged finish — while being the only version that lasts. Judging a patch means judging its edges, its coats and its cause, not its first photograph.
- Our Services
Types Of Services We Offer
Stucco Patching & Local Rebuilds
Failed areas on an otherwise sound stucco system cut back to sound layers and rebuilt coat by coat, with the finish texture matched to the wall around them.
Sounding Survey & Hollow Stucco Repair
The wall tapped and read before it is priced: hollow, delaminated areas mapped to their true edges, so the patch covers the failure that exists, not just the part that shows.
Cut-Back To Sound Layers
A patch is only as sound as its edges — failed coats come out to where they are genuinely bonded, even when the honest patch is bigger than the visible damage.
Three-Coat Patch Rebuilding
Scratch, brown and finish coats rebuilt in the wall's own order over masonry or lath, each coat cured before the next — the wall's construction in miniature.
Texture & Colour Matching
Smooth, sand or dash finishes replicated by aggregate and technique, sampled against your wall first — with the weathered-wall limits stated openly.
Stucco Over Masonry & Lath Repairs
A patch over solid masonry and a patch over lath on a framed wall are different rebuilds; each is scoped and built for the substrate actually under the coats.
Painting Sound Stucco & Brick
Painting is not repairing: once a patch is sound, painting stucco or brick as a finish scope — preparation, systems, colour — lives on our exterior painting page.
Facade Repair & Restoration
Where local failure turns out to sit inside a whole-elevation problem — joints, units and junctions across the wall — the programme scope lives on our facade page.
Searching for Stucco Patching & Repair Contractors Near Me?
If you are searching for stucco repair contractors near you in New York, the useful question is who sounds the wall before quoting the patch — and who will tell you when the failure has spread too far for patching to be the honest spend. RT General Construction Inc is based in Yonkers and patches stucco across Westchester County, the Bronx, Manhattan and Queens — stucco colonials, stucco-clad houses and small buildings, where the owner deals with one contractor for the survey, the written scope and the work itself. Every wall is assessed in person and sounded by hand, and the scope states the patch’s true edges and the cause being corrected with it. Once a patch is sound, keeping its finish looking right is a separate, later question — painting sound stucco is scoped on our exterior painting page, never sold as the repair itself. Call us or send the form on this page to arrange a free estimate at your property.

- Why Choose Us
Patches Cut Back To Sound Layers — Or Not Sold
A stucco patch is the easiest repair in this trade to fake: fill the hole, match the colour, photograph it fresh. Our discipline is the unglamorous opposite — the wall sounded by hand before it is priced, the true edge of failure found past the visible damage, the cause corrected in the same scope, and the patch rebuilt coat by coat with its texture sampled against your wall. And where the sounding says the system has failed beyond patching, you hear that from us before you have paid for the next patch.
- Sounded By Hand Before Pricing
- Edges Cut Back To Bonded Coats
- Cause Corrected With The Patch
- Scratch, Brown And Finish — In Order
- Texture Sampled, Limits Stated
- Patch-Versus-Renewal, Told Straight
The Honest Patch Is Often Bigger
Failure extends past what shows; we show you the sounding map first, so a larger patch reads as evidence, never as upselling.
EIFS Is Never Patched As Stucco
Foam-and-mesh assemblies are a different system with a different repair logic — if your wall is EIFS, we say so and scope it as itself.
Paint Is Never The Patch
A coating over failed stucco is a photograph, not a repair. Repaired, sound surfaces are handed over ready for the finish scope that follows.
- Our Process
Process, How we Works.
01
Areas That Sound Hollow When Tapped
The coats have separated from the substrate or lath beneath. The surface may look perfect — the bond that held it is already gone, and the area will grow.
02
Bulging Or Soft Patches
Water has been at work behind the finish, softening coats or the material under them. A bulge is the wall reporting damage wider than the stain beside it.
03
Local Cracks, Chips And Impact Holes
Failed areas with sound wall around them: the classic patch scope, provided the cause — movement, impact or a local entry point — is read and corrected with it.
04
Staining Below Sills And Penetrations
Marks under window sills, fixtures and pipe entries show where water gets behind the skin. The patch and the entry detail are one scope, or neither holds.
- Benefits
Benefits Of Hiring Us In New York
A patch is a promise that the failure stops here. Here is what the sounding-and-cut-back discipline gets you.
The Patch's True Edges, Found First
The wall is sounded before it is priced, so the scope covers the failure that exists — not just the part of it that shows.
Cause Corrected In The Same Scope
The entry point or substrate failure behind the patch is fixed with it. A patch over an open water path is cosmetic, and we do not sell cosmetics as repair.
Rebuilt Coat By Coat
Scratch, brown and finish, each cured before the next — the patch is the wall’s own construction in miniature, not a fill.
The Patch-Versus-Renewal Call, Told Straight
Where hollow areas have multiplied across an elevation, we say patching has stopped being the honest spend — and show you the sounding that proves it.
- Our Projects
Proven Quality, Best Results
- Testimonials
Built on Trust, Proven By Testimonials
98% Clients Are Positive Reviews 1 2
- Our Faq
Clear Answers to Your Construction Questions
What Does Stucco Patching And Repair Cost In New York?
Cost turns on the number of patches and their true area once sounded — which is often larger than the visible damage — the state of what is found underneath, because coats over masonry and coats over failed lath are different rebuilds, whether the cause behind the patch — an entry point or a substrate failure — needs correcting in the same scope, the texture-matching difficulty of your finish, and the access the elevation needs. We assess and sound the wall in person and price the written scope patch by patch, so the figure rests on the failure as found, not as photographed.
Why Does My Stucco Sound Hollow Or Bulge?
Because the coats have delaminated: the bond between the stucco layers and the masonry or lath beneath them has broken, usually after water got behind the finish and worked at the bond through wetting, drying and freezing. The surface can look smooth while it is held by habit and its own edges. Hollow and bulging areas are failed material — they cannot be glued back by a surface coat, and they grow as water keeps reaching them. They come out to sound edges and are rebuilt.
Can A Patch Be Matched To My Existing Stucco?
Closely, with method — and with honest limits. Texture is replicated by technique: a smooth, sand or dash finish is matched by aggregate and application, worked from samples judged against your wall before the patch is final, because a flat patch on a dash wall announces itself no matter how good its colour is. Colour on a weathered wall is the harder half — aged finish has faded unevenly, so a new patch may read fresher until it weathers in. Where that difference would bother you, the honest alternative is a finish renewed across the whole elevation, and we will say so openly.
Patch Or Full Renewal — How Do I Know Which My Wall Needs?
By the failure census, not by the worst-looking patch. Localised hollow areas, cracks and damage with sound, bonded stucco across the rest of the elevation: that is patching, and it is the right spend. Hollow or failed areas multiplying across the elevation, lath deteriorated wherever the wall is opened, water damage in the substrate at several levels — the system, not the spot, has failed, and patching becomes a subscription to repeat visits. The sounding survey gives you the count and the map; where it says renewal, we tell you plainly rather than sell the next patch.
How Long Does A Stucco Patch Take, And How Long Between Coats?
Duration turns on the patch’s true size once cut back, what the opening finds underneath, and the coat sequence itself: scratch, brown and finish coats are separate applications, each needing its cure before the next goes on — rushing the sequence is how patches crack and debond. Weather matters, because cement coats cure poorly in freezing or driving wet conditions. Your written scope sequences the coats and names what each stage waits on, rather than promising a calendar the wall has not agreed to.
- Services Areas
Proudly Serving Across New York
From interior renovations to exterior restoration, RT General Construction Inc delivers dependable construction and remodeling solutions for residential and commercial properties across New York. Our team handles everything from masonry, concrete, roofing, and exterior repairs to kitchens, bathrooms, painting, and interior improvements.
- New York
- Jerome Park, NY
- Village of Pelham, NY
- Harlem, NY
- Eastchester, NY
- North Side, NY
- Yonkers, NY
- New Rochelle, NY
- Pelham Manor, NY
- Mamaroneck, NY
- Larchmont, NY
- Tuckahoe, NY
- Hastings-on-Hudson, NY
- Scarsdale, NY
- Bronxville, NY
- White Plains, NY
- Manhattan, NY
- Astoria, NY
- Long Island City, NY
- Fresh Meadows, NY
- Flushing, NY
- Bayside, NY
- Queens, NY
Let's Build Something Amazing Together
Tell us about your project and we will arrange an assessment, explain what the work involves and provide a written scope before anything begins. One contractor, one plan, one accountable team — that is how RT General Construction Inc runs every job, large or small.